RC Car BMT 802 Buggy PRO 1/8 Competition Buggy
Earn 90 points/€2.70
(Each €5.00 spent = 1 point, 1 point = €0.03 discount)
RC Car BMT 802 Buggy PRO 1/8 Competition Buggy
BMT 801 is a pure competition rc car. Is a new evolution of 1/8 buggy car BMT!
It’s supplied as an assembly kit, complete with body and tyres.
Chassis:
The chassis is in alu 7075 light version, with Hard anodization.
It’s has already the front and rear reinforcements.
All the transmission of the model are cardan, at the front and rear CVA , the crowns and pinions of the differentials are made by steel, and the whole turns on ball bearings.
The shock absorbers are hydraulic (with oil), they are of the new Big Bore 17mm type and are completely in aluminum with a 4.0mm steel stem and adjustable by means of a ring nut to vary the spring hardness.
The shock absorber supports are in ergal 7075 from 4mm thick and have various holes for fixing the shock absorbers in order to change the attitude.
The brakes Pads are in Real Ferodo, with the same process of realization of the true cars 1/1. They are double disc, one acting on the front axle and one acting on the rear axle in order to vary the braking power on the two axles.
The suspensions are fully adjustable, with upper triangle, at the front, with adjustable position, and rear tie rod. All angles like camber, convergence, height etc. they are adjustable.
Suspension arm, include arm stiffner in carbon, for reduce and increase hardness.
The rear upright is in alu 7075 for increase durability and perfomances.
In addition, the front and rear suspensions are equipped with adjustable anti-roll bars for maximum perfomances!
The whole electronic part is protected by an airtight dustproof box with extra battery box to balance the weight of the model.
The lexan body is supplied already precut.
The tires and rims are supplied in the kit, they are pin with medium compound that fit most of the land.
Engine Accessory:
It’s Included, competition clutch system, and air filter.
Unassembled car kit
Front Steel Skid Plate
Carbon plate for Suspension Arm is included
Radio plate, and central plate is in carbon
Rear Hub in alu 7075
Precut Body included
Chassis 3mm ergal Light
Suspension pins in steel
Electronics in an airtight box
Fuel tank with filter
Double disc brakes with racing pads
3 Gear differentials
Double-stage air filter
17mm Big Bore shock absorbers
Front shock absorber support in 4mm ergal
Rear shock absorber support in 4mm ergal
Chassis reinforcements
Rear mud guards
Rear and front stabilizer bars
Adjustable steel tie rods
Adjustable metal shock absorbers
Racing clutch
Some new parts compared to the 801 model:
New differentials
New engine mount
New clutch 34mm
New radio plate with adjustable battery position
New servo saver with ergal plate
New bodywork
Technical data:
Scale: 1/8
Length: 460mm
Width: 306mm
Height: 140mm
Wheelbase: 322mm
Weight: 3600g
To complete the model car:
Engine and Pipe Set
Radio and servo's
